Cletrac.org

Cletrac Tractor Discussion => Military Cletracs => Topic started by: Matt Rimmer on August 10, 2011, 11:34:40 AM



Title: M2 Shop Manual
Post by: Matt Rimmer on August 10, 2011, 11:34:40 AM
Hi,
I have been trying to get a workshop manual for my M2 before doing any work on the clutch but so far have drawn a blank,I have the operators instruction book and have just ordered the parts book from Portrayal Press but if anyone can point me in the direstion of a workshop manual I would be very grateful,or if anyone can scan the section dealing with the clutch that would be a huge help!.

Thanks,

Matt.


Title: Re: M2 Shop Manual
Post by: Jim Baker on September 17, 2011, 11:58:12 AM
Matt, I have a Maintenance Manual for Cletrac Model MG1 , and Ordnance Model Medium M2 - (United States War Department) which I got from  Landis Zimmerman (olivercletrac.com), to the tune of $51 including shipping.  My reason for getting is was to glean as many photos as possible that would help me build a scale model.  I have done that (although I am WAY behind in making the model).  It did not take any ink off of the pages!  So if you would like to have it for, say $30 plus postage, send me a note.  I think it weighs about a pound, but don't know where you are, so will have to figure out the postage.

Jim


Title: Re: M2 Shop Manual
Post by: Matt Rimmer on September 18, 2011, 05:52:02 AM
Hi Jim,

Many thanks for your reply and kind offer. I managed to source the reprint manuals from a guy in Belgium via another UK Cletrac owner(thanks Paul!).

Matt.


Title: Re: M2 Shop Manual
Post by: wanderingwillys on October 16, 2011, 10:08:14 PM
I have a repo shop manual - what about the clutch are you looking to find out? It'll be tomorrow but I can scan in the pages... Let me know what you're after...

Matt


Title: Re: M2 Shop Manual
Post by: wanderingwillys on October 17, 2011, 07:53:56 PM
If anyone else needs the section I have it as a PDF file - just under 1 MB so it's to bit to post up here but happy to send it where ever...

Matt


Title: Re: M2 Shop Manual
Post by: Blake Malkamaki on October 17, 2011, 10:44:33 PM
I could put it right on the site Matt. If you want you can email it to me. 1 mb isn't that much to put on the site.

Thanks,
Blake


Title: Re: M2 Shop Manual
Post by: Blake Malkamaki on October 18, 2011, 06:50:06 PM
I put the engine specifications and clutch service bulletin here: http://cletrac.org/pages/specifications.html under "Technical".

Blake


Title: Re: M2 Shop Manual
Post by: Matt Rimmer on December 23, 2011, 01:54:29 PM
Many thanks guys. I'm still waiting for my water pump to come back from the rebuilders,it's been three months with several excuses from them,I think I'll have to ask them to just send it back and I'll find another place to do it.

Matt.