Print Page - OC-12 with Oliver blade.

Title: OC-12 with Oliver blade.
Post by: John Schwiebert on April 30, 2005, 11:30:28 PM

I need a picture of one . What kind of linkage is used to support the blade from the push arms. One side has a turnbuckle the other side is ridgid. Which side is correct?

Title: Re: OC-12 with Oliver blade.
Post by: Blake Malkamaki on May 01, 2005, 12:39:37 AM

Quote from: "John Schwiebert"I need a picture of one . What kind of linkage is used to support the blade from the push arms. One side has a turnbuckle the other side is ridgid. Which side is correct?

John, my OC-12 is over at my cousin's now, but when I get it back - or get over there with a camera - I will take some pictures for you.

There are different blades for the OC-12: a grader blade which angles and is lower, and a bulldozer blade which is higher and does not angle. My blade is about 3 foot high. The bulldozer blade does tilt via the turnbuckel.

Blake

Title: OC-12 with Oliver blade.
Post by: John Schwiebert on May 01, 2005, 01:45:02 AM

Blake: Thanks, there is no rush. This is a fall project. I will get you more details too. Thanks.

Cletrac.org

Cletrac Tractor Discussion => All Models Except HG, OC-3, OC-4 & General => Topic started by: John Schwiebert on April 30, 2005, 11:30:28 PM