Title: Commonality between Cletrac HG and Moline BG Wheel Tractor?
Post by: Orangeman on September 24, 2005, 10:53:32 AM
Post by: Orangeman on September 24, 2005, 10:53:32 AM
Hi Guys: Need some expert help... my Moline friend is working on his Moline BG wheel tractor... his Timken Bearing Races and Snap Rings need to be replaced. The machine uses a Clark 4 speed Transmission... Is there commonality between the tranny in any Cletrac Application and his BG. We need to replace either new or new old stock the following Timken Bearing Races and Snap Ring. The part numbers are as follows:
1. 31523RB
2. 15523RB
Any bearing and transmission experts really could use your help. Glad to be back on the board after a beautiful summer. Take Care Cletrac Guys!
Orangeman!!!
1. 31523RB
2. 15523RB
Any bearing and transmission experts really could use your help. Glad to be back on the board after a beautiful summer. Take Care Cletrac Guys!
Orangeman!!!
Title:
Post by: Blake Malkamaki on September 24, 2005, 10:10:20 PM
Post by: Blake Malkamaki on September 24, 2005, 10:10:20 PM
Is the BG Moline the tractor that came from the BF Avery? If so, it's very close to the Cletrac General as Cletrac made the BF Avery tractor.
The General and HG use a Clark transmission.
The General and HG use a Clark transmission.
Title: Reply to Black
Post by: Orangeman on September 25, 2005, 02:42:06 PM
Post by: Orangeman on September 25, 2005, 02:42:06 PM
Blake: Thanks for the reply... is the cletrac HG a three speed or four speed Clark? Yes the BG is the machine that was purchased from Avery.
Yes the BG is the machine that was purchased from Avery.
Title:
Post by: Blake Malkamaki on September 25, 2005, 06:00:32 PM
Post by: Blake Malkamaki on September 25, 2005, 06:00:32 PM
I was thinking it was a model BF.
The General and HG were 3 speeds, but I have a 4 speed for an HG.
Blake
The General and HG were 3 speeds, but I have a 4 speed for an HG.
Blake