Print Page - HG 42 Throttle lever

Title: HG 42 Throttle lever
Post by: yellowcrawler on April 04, 2006, 01:55:08 AM

I bought a new throttle lever to replace the cobbled replacement. Since I have not seen an original installed, does a 1/4 inch ball or a pin fit along with the spring in the body of the lever?

Thanks,
Walter.

Title: throttle
Post by: walter hudson on April 04, 2006, 11:30:53 PM

the lever should have a piece of hardened rod that is ground like the edge of a chisel but not a real sharp point .
walter

Title: Throttle Lever
Post by: yellowcrawler on April 05, 2006, 01:58:25 AM

Thanks for the information on the pin, I will make up one.

Is a pin used for the pivot point on the lever? A long 1/4 inch bolt is used as a pivot on the present lever.

I have the proper clevis for the rod to the governor.

Thanks,
Walter

Title: throttle
Post by: walter hudson on April 05, 2006, 02:56:23 AM

I normally use a bolt with a lock nut.

Title: throttle
Post by: yellowcrawler on April 06, 2006, 01:26:52 AM

Thanks for the information!!

Walter.

Cletrac.org

Cletrac Tractor Discussion => HG, OC-3, OC-4 & General => Topic started by: yellowcrawler on April 04, 2006, 01:55:08 AM