Title: fourth gear is on strike
Post by: GaToy on May 20, 2006, 11:15:12 PM
Post by: GaToy on May 20, 2006, 11:15:12 PM
I was messing with my dozer the other day and for the first time I wanted to see what each gear was like. 1rst and 2nd was fine. Then when I put it in 3rd it bogged the engine down and then once it got going the rpm's went back up and drove fine. But when I went to put it in 4th all it would do is bog the motor out. I tried from both dead stop and a rolling start. Either way the motor would die out. Would that be the clutch or what do you think would be the problem?
~C.C.~
~C.C.~
Title: oc4
Post by: walter hudson on May 21, 2006, 12:51:27 AM
Post by: walter hudson on May 21, 2006, 12:51:27 AM
if you are stalling the engine it will not be the clutch . you might try a good tune up.
Title:
Post by: GaToy on May 22, 2006, 07:17:50 PM
Post by: GaToy on May 22, 2006, 07:17:50 PM
Oh, so you figure it could be something as simple as that? I'll give it a try. Thanks. 
~C.C.~
~C.C.~
Title: oc4
Post by: walter hudson on May 23, 2006, 01:45:32 AM
Post by: walter hudson on May 23, 2006, 01:45:32 AM
be sure to check your gov. linkage adjustment ,ign. timing, and carb. during your tune up.
good luck
walter
good luck
walter