I said I'd post some photos of this awhile back, so here it is.
The first photo shows it with the bucket fully up. You can see the swinging bars stowed along the sides of the bucket tilt arms. These are flipped over and back and they grab pins on the tool bar. The tool bar and bucket tilt are then linked allowing the tilt cylinders to now operate the tool bar.
You can also see the hood cutout as has been mentioned in another post. This one isn't too nicely done, with three barn door type strap hinges on it.
Here you can see the tool bar in operating mode. There is a swinging hook on the right arm that grabs a pin in the tool bar in the up postion when the operating levers are in the disengaged postition. Pretty nifty. The rippers don't fit it, by the way.......just a handy place to store them for the time being. I don't have any ripper that do fit, but hope to find some.
Mike
Jeremy,
I'll try to email some photos tonight.
Mike