Print Page - wico xh lag setting

Title: wico xh lag setting
Post by: tcr on September 04, 2006, 06:56:45 PM

Hi;
does anybody know what the lag should be set at on a wico mag model xh 1113? It is on an oc-3. Or what is the best way to figure out where it should be set at?

Thank You

Title: lag
Post by: walter hudson on September 06, 2006, 12:46:51 AM

The timing advance is 14 degrees btdc . Your lag should be close to 14 degrees so when you crank the timing is pulled back to tdc .

Title: lag
Post by: walter hudson on September 06, 2006, 12:49:25 AM

If you have the correct mag the lag angle should already be correct. I believe that wico xh1113 is correct for that model .

Title: Re: wico xh lag setting
Post by: craigsmagneto.com on August 07, 2009, 01:23:53 AM

On XH 1113 Lag angle is 21* out of WICO Manual. Can give me a call Craigs Magneto Service 530-246-2747. ( California).

Cletrac.org

Cletrac Tractor Discussion => HG, OC-3, OC-4 & General => Topic started by: tcr on September 04, 2006, 06:56:45 PM