Cletrac.org

Cletrac Tractor Discussion => HG, OC-3, OC-4 & General => Topic started by: Murray on March 13, 2007, 01:02:17 AM

Title: Confused about bore size IXB-3
Post by: Murray on March 13, 2007, 01:02:17 AM
Hello
I am a little confuse about the bore size.  I took the head off of the engine to see what I should pick up for rings.  The top of the piston reads 3.247  There was very little ridge so I figured I would order standard rings.  The standard size according to the books he had was 3.250.  I told him to order them in.  Today I measured the bore with my bore gauge and it tells me 3.249 .  Does anyone have the factory specs handy?  Ii have ordered a manual but it won't be here for at least another week.  I must have one of the better ones, my engine is getting newer instead of older.  If anyone has the spec sheet page.  I would really appreciate a copy e-mailed to me.  Oh and If anyone is looking for Oliver OC3 Cletrac HG Track Pins and Bushings Item number: 220089665480 on e-bay.  To far away for me.

Thanks
Murray
Title: PISTON
Post by: walter hudson on March 13, 2007, 01:25:29 AM
Bore is 3.25 ,piston clearance is .0025-.003 at the skirt .ring gap is .015-.020. you should have standard pistons since the top will be smaller than the skirt .
Walter