Print Page - HG "U" joints

Title: HG "U" joints
Post by: VaMike on March 06, 2008, 03:54:35 PM

Does anyone know of a source for Spicer type joints in the 1-3/16"X6 spline?
Best,
Mike

Title: Spicer parts
Post by: Mike Shanley on March 12, 2008, 02:43:03 PM

I believe the spline shaft and U joints are the same as those used in the Ford Model A cars. Try your local Model A gear heads. Mike Shanley

Title: U-joints
Post by: John Schwiebert on March 12, 2008, 02:55:42 PM

Well I think you are half correct. The early ones are like a model A Ford. The later ones are Spicer. I got some made for Landis a long time ago when I worked for Dana (Spicer). Now do you need both halves?

Title:
Post by: VaMike on March 15, 2008, 02:23:04 PM

I am seeking a yoke to use on a HG transmission for a re-power. I want to use Spicer u-joints as they are easy to find, and I can have a drive shaft made locally.
Best,
Mike

Title:
Post by: Les Darsow on March 31, 2008, 02:37:18 PM

I have found them in a catalog at Catco. Any Dana/Spicer dealer can order them. I have the part number as : 2-4-1301. It is found on the Dana website via Catcoparts. Go to "Expert System" then go to "Driveshaft" then go to "Identify Part by Dimension" then go to "End Yokes" then go to "Splined (all others)" then go to "Select a Series 1310". It is listed as a 1.883 x 6
I hope this helps.

Cletrac.org

Cletrac Tractor Discussion => HG, OC-3, OC-4 & General => Topic started by: VaMike on March 06, 2008, 03:54:35 PM