now you would think that a smallish sized dozer blade would be pretty easy to find....not so...
looking for ideas and a source for a small dozer blade. Ideally, 5 feet wide at most, 2 feet tall at most, and NOT too heavy!
My attempt at using a simple drag type 3pt blade on my HG42 is working, but I want a little more "umph" with a more stoutley built blade.
ANyone got one they wanna get rid of? No need for mounts, hoses, pumps ,etc.. I am all set there. Just looking for blade, a better, stout blade to fit onto my custom made lift mechanism.
Like I said, any simple, light to medium weight blade will do.. must be 5 ft or so..too small wont work, and I am trying to keep the size and weight down... my tracks are 52" wide. Needs to be at least a little wider than that to work right for me.
anyone? I am in the Dallas, TX area. Closest would be great so I can go get it, but if reasonable shipping or other deleivery is possible, Ill consider anywhere.
wc57doggieboy@yahoo.comdachoppa
Have you considered making one?
I built one for my first OC3. In fact, built the whole shebang from scratch.
Found a section of a boiler with 1/4" plate and a comfortable radius, 6 1/2 ft long and about 15" wide for the blade.
Welded both edges of a piece of 2 x 2 x 1/4 angle to the bottom back for reinforcing. A section of used grader blade was bolted on as a cutting edge, later welded as the bolts wore off.
Another piece of angle 2 x 2 x 3/16 welded as an L on the top edge of the boiler plate. As well as reenforcing and a hand-hold for wrestling the blade around when disconnected, it gave a lip for hooking on chains for tiedowns on the trailer.
I cut 4 pieces of 1/4" plate to fit the back of the curve for reenforcing. 2 for end plates, 2 more nearer middle to hold 2 more pieces of angle for a mounting socket. 2 1" rods about a foot long with loops welded on top for pins to hold the blade onto the mounting plate on the main push arms extending forward from inside the tracks.
And a spacer block to put in one side or the other to angle the plade for snow plowing.
This blade was 6 1/2 foot long, weighed probably 150 pounds, and stood up to all kinds of abuse. It was still straight when I sold the tractor 20 some years later.