hi all,
I'm going to attempt to fit a perkins 6345 perkins motor into my BDH
has anyone Else attempted this or have achieved it
if so has anyone got any pointers ??
All Help Appreciated
Scott
When I went to the UK either 7 or 9 years (I went twice) ago I stopped at a collector that had done this. It looked real good.
I too am looking for an alternate diesel engine for a BD. It would have to be similar low RPM, but a little more horsepower would be OK.
What are the specs on a 6354?
Wes
I think a B5.9 series Cummins 12 valve would be a good option. Torque peaks around 1400, but they can be run up to around 2900 if desired. And, with a little modification, you can get all the power you want. A 24 valve or common rail would work too, but you'd need the computer.
Blake
Another good choice is a John deere 6-329. I spoke with the owner of Bechtold Tractor service from Ca., a few years ago and he told me they re-powered a lot of OC-12's with the Deere engine and it was a good fit. They are not too hard to find as they were used in a lot of combines.
Even a 4BT would be a good fit. Maybe even some of those Deutz air cooled engines. They seem to be a decent engine
Hi Guys Thanks for you input
I have almost achieved putting the Perkins 6354 into the crawler
just awaiting the adaptor between the Perkins and the BDH Flywheel
Have a look at the Progress:
https://www.facebook.com/media/set/?set=a.10151910848706269.1073741825.681496268&type=1&l=6a7d55d057
Scott
Scott: Can you post a short write up on the materials and engine swap out when you get a moment.
Did you machine the adaptor plate yourself or did you secure from a metal fab. shop.
Keep up the good work!