After pulling my engine, I noticed about a cup+ of gear oil collected within the bellhousing. Is this something to be concerned about? I imagine theres no front seal, so it's most likely coming from a gasket? Also, the engine plate indicates that I have an F226, but I've read that the AG6 has an F6226. Would the plate state F6226 or has the engine been replaced? I know the F226 was common in other tractors and autos.
I don't think I'd worry about the oil leaking into the bellhousing too much, but I believe there should be a small drain hole in the bottom where the oil should have drained out.
The AG6 has a Continental F226. That is right.
Blake