Cletrac.org

Cletrac Tractor Discussion => HG, OC-3, OC-4 & General => Topic started by: mleves on September 24, 2004, 06:16:41 PM

Title: A couple questions about the OC46
Post by: mleves on September 24, 2004, 06:16:41 PM
Hi,  I've got a couple quick questions about a gas (3cyl) OC-46

1.  Does anyone know the Fram #'s for replacement engine oil & hydro filters?

2. Does the 6 volt (gas) system take an
actual 6 volt battery?

3.  Any idea on where I could find a new
driveshaft (engine to trans) or at least just new U joints?

how much it would cost?

Thanks very much!

mike.
Title:
Post by: pvcarey on September 25, 2004, 12:48:07 AM
I don't know about the motor, but the ujoints or whole driveshaft should not be hard to find, I don't know where your at but check the yellow pages under drive shaft, or bearing supply, farm store, or if you have a good parts store thay can order same size. hope I was some help