I can not remove the rear spider joint. The 1-5/8" castle nut will not budge. The nuts and threads appears to be well lubricated, not rusted or abused. I've put it in 1st and reverse to counter the pressure of the wrench. But... not luck. The gap between the two splines is ~2". Just not enough to lift the front spider joint out and allow the pilot bearing, clutch and pressure plates to follow.
Any Advice on how to increase the gap, between the splines, to allow for removal of front spider.
Or how to get that rear spider off.
I know my verbage is not correct but, I don't have my manual in front of me for a proper parts name reference.
Thanks,
BRACK
Any Advice on how to increase the gap, between the splines, to allow for removal of front spider.
Or how to get that rear spider off.
I know my verbage is not correct but, I don't have my manual in front of me for a proper parts name reference.
Thanks,
BRACK