Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Bre620

#1
Well i had to push this off the trailer as I've had no luck starting this cletrac. :( I'm starting to think this cletrac was not running last summer. Anyway, I tested  continuity thru spark wires and thru distributor cap. It's there. Just no spark from the mag. I found the magneto to be a Bosch DU4. I may have to get a replacement or have it rebuilt. I did go thru the contacts and clean them all. I have a few more questions:


What are the gap settings in both the spark plugs and mag point?
Where is the condenser in the magneto and how can I test it?
Where is the hole I look thru for the timing marks and what do I line them up? To what? I only see marks on the fly wheel.
It seems to me the carb is getting some sort of back pressure thru carb. Gas is being push back thru the float check while cranking.

I appreciate the help and sorry the wait on the update.

David
#2
Bruce and Bill,
Thank you both for the great advice. The impulse coupling must be work as I do hear a "snap" or click. The information on the spark advance/retard control I didn't know, thank you. I'll give it another try this weekend and but your advise to use. Fingers crossed!

David
#3
Hello everyone David here,
I just picked up this cletrac (model W I think). I was told it is a 1918 and was running as recently as last summer. I'm having trouble getting it started thou. What is the starting procedure on these?

I have drained and put fresh gas in the tank.
Removed and cleaned the carb. The carb needs more work but it should work well enough to move the cletrac. I need to get it off my trailer. I'll revisit the carb work at a later date.

At this point it think I'm NOT getting spark. How can I test the magneto to be sure it's working properly. Should I remove it, take it apart and clean it?  Any help here would be appreciated.

A far as the carb goes I need to source new throttle plates and I'd like to find new shafts as well. It looks like the plates are 1.25 dia. Do any of you know what plates and shafts I could use?

Thanks