That were my thoughts. I have all ready had it on my positioner, was just curious if there were any other ideas THANKS IN ADVANCE!!
- Welcome to Cletrac.org.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
HG, OC-3, OC-4 & General / Zimmerman drive sprockets
February 02, 2017, 07:04:54 PM
My father and I are working on an HG/ OC-3. He has purchased a set of weld on drive sprockets. Am looking for help as to removal of the old and welding of the new, I am a Fabricator by trade so we have ideas but looking for advise from "The Guys in the KNOW".Thanks
Pages1