Messages

  I have thought the same Dustin.  From a quick look the bellhousing adaptor needs to be 2" thick as the flywheel ring gear on the IH is larger than the ID of the Cletrac. A longer input shaft and a release bearing spacer for the IH clutch. Radiator and hood are good to go.
mike

Just declare the package as used tractor parts and mark the box the same. The other end gets $US to send back, `course I only got Canukabucks.
mike

Bob, I have sent parts to Australia via Canada Post. I would think USPS would as well.
mike

No joy here, the guage said 60 ton when everyone disappeared around the corner with the  " remote ". The BANG was sure impressive tho`.
  mike

I checked the tags, now comes the quandary. They are ADHL 2Z956 and ADH 2Z974, it is possible the trackframes don`t belong?
  Roller diameters are OD. - flange is 8 1/2" - face is 6 3/4".
  Sprocket is 23" tooth tip to tip. There would be a 1/4" elevation of the shoe off the ground sitting level.
 Bob, the spokes have been reinforced each side of the web.
   What have I got?
 mike

I discovered two of them at a fishing camp out of town in 1980, one was beat to death including the tub.  Upon retirement the resto began, with parts comming from Pa. it took 2 years to complete.
  As to it`s  originality as an "L"  I can only go by the 2 tags that were present on the firewalls.
 This foto was the start point.
 mike

I will give this a try, fotos aren`t  my specialty. It is supposed to have a bumper but is missing.
 mike

Bob, thanks for the weight clarification.

 ubucat, yes it is an ADH -the tag reads ADHL  and is a 1946 model. In small print it sez made by Oliver and sold as a Cletrac. IMO, the price is reasonable.
 mike

I went and measured my AD and the sprocket centres are 50". Looks to be a good find.  I have some water pump pieces if your in a bind. The weight should be around 5 1/2 tons.
 mike

Bearing supply houses and  Caterpillar dealers have felt available.
mike

I find that the front wheel drive small car cv boots work well on shifters. The axel end is close to the correct fit.
Good luck
mike

hopefully the new bb will be able to ward off the attacks,thanks for the hard work blake.
   mike

hello adh man
  what do you need,i have some parts
                mike