Ag6h governor and hydraulics

[G Huffman]

We had 6' of snow in two weeks ( rare for Colorado in the area I am) and broke brothers snow plow four times and the AG6 could not pull him out when he got stuck.  The AG6H went over the blown snow quite well.  The hydraulics were out so plowing was quite difficult.  Then the governor blew up.  There was a sound like the water pump bearings were going then a bang and when I looked the top and right side of the governor was missing.  I think I have another from my Terra Track forcklift but kind of hate to use it.  Does anyone have any ideas on what kind of hydraulic pump I can put in the  place where a magneto goes?  I think that would make a better hydraulic system and I can put the big hydraulic pump on the PTO for a log splitter.

Thanks

[G Huffman]

I have taken the governor off and the insides look good but the case is shot.   Anyone got a governor case for the F226?  I looked into the F162 hydraulic pump and tried to install it on the Cletrack.  The cam gear, I am guessing is too large in the F226 to accept the F162 governor  and hydraulic pump.

Anyone got a governor for the F226 or know where I can get one?