Messages

Glad to help. I think k 20s have 8 bolts holding down engine.   Bill

Tim, its Bill  The bolts that hold the engine to the frame have sleeves thru the block and into the frame.Use a punch to drive the sleeves out.The engine should slide very easy on the frame rails  forward with just a tug.Also there are 2 bolts/screws that hold clutch peddle yoke to the throwout coupler that have to come out also.c Clutch input shaft will stay with engine when it slides forward.  Hope this helps.  There also some times shims between block feet and frame rails.  Bill  CT.

Yes crawler tractors can be pull started. I have done it many times.Use high gear.  Bill in CT.

So it is an option  that is not needed ? Bill CT>

I just picked up a 2 owner 1935 EN.It is pretty complete and has a 3 foot snowplow.At the right rear of the engine is what appears to be a small mechanical fuel pump.I have never seen this before. My 1937 E 38 doesn't  have one.Is this some type of option ? The EN parts manual that came with this tractor,has a listing for an AC fuel pump.It also says no parts for this pump can be purchased from Cletrac,you must go directly to AC for pump or repair parts.I thought all these tractors were gravity feed.Has anybody seen,or about this set up ? Puzzled Bill in CT>

Hi Jon, Long time no hear. This not my tractor,its a new members his name is Cord. Whats up with your machine ? I just Picked up a nice EN with a snow plow last week. Been looking for one of those for a while.Only about 1/2 from my house. Take care Bill in CT,

Cord , I sent you a private message ,let me know if you get it, Thanks Bill

Richard,both my K s have the steel W type steering wheel.I assume you want original gas caps and the rear power pulley?  Bill 203 993-4771 Lets talk.

I picked up a K 20 today.Engine is stuck and head is off.Pretty complete tractor . I may use it for parts for mine.Is anyone looking for a K 20 project, or just parts.Also cletrac/Weidly engine parts.Still have E 38 parts tractor also. Bill in CT>

Arent, K20 engines the same cletrac engine as the W,which is a babbit bearing engine? Bill

My K 20 could use an engine replacement.The engine in it now is very tired.Lots of blow by etc.Because it is a babbit bearing engine,rebuild is $$$$$.Plus parts are non-existent. Does anyone have decent running cletrac engine.W uses the same one. Bill in CT.

Hey, Johnny lunch pail Dont forget I have a pretty complete E-38 parts tractor. Bill in CT>

New clutch in W works perfectly,is what I meant. Bill

It works perfectly! Here's a picture of the fleet before I put them in for the winter. http://imgur.com/a/Gd7Cm

Richard, Go to youtube Kent CT fall festival, video posted a week ago by Trukluver.5.25 min is me and my E-38 styled.Bill in CT.