Messages

Glad to see the Machine in action, miss the old girl,was fun to drive and use.
Curt

I used a farmall h dist with mount to replace mag,
fit nicely with little mod to drive coupling.
found one on ebay cheap.
need to relocate coil to engine to clear carb.
Curt

thanks for the ideas!

will get 2000 psi gauge and check pressure on pump first, what would ideal pressure be on pump?
thanks
Curt

hello,
Do any of you guys have number or info on packing kits for ware 3wi loader cylinders? 1955?
mine seem to be bypassing somewhere under load, no visible leaks, but no power when trying to lift.
suggestions? sounds like it is bypassing somewhere?
Curt G

try using a die grinder with new thin blade,cut down into cap at 90 degree angle,being careful only to go just below depth of clip this will allow use of a pic or pointed awl to get under clip to remove pieces, also would permit removal of new clips later. used this method on several when installing model a trans setup in my oc3.

John,
 VERY NICE JOB, your tractor lokks great. the item you asked about is a water jacket pre heater, to use you put old style blow torch hung from a bolt screwed in hole to direct heat in the end of water heater, takes awhile,but helps some. I have a 47 with same attachment also have a 52 bd without it, you need to find the old style blowtorch with the hanging eyelet on top, thaks for pics.
                                                                                                                            Curt

hello,
Am in process of installing model a in oc3, have question about disassemly of model a joint is there a special tool or how do you get  round snap ring out to take apart? would like to use two nice u joints i acquired to make short shaft as shown on this aux trans page, all very well done material and has been very helpful so far.
thanks
Curt

hello,
was wondering if anyone had dimensions of side radiotor tin for 55 oc3,or if anyone close to port henry ny had this tin and grille guard for ware 3wi loader setup, its the one that has round holes drilled in it? Iam in need of finding or fabricating these for my new winter project, any help would be appreciated.

                                                                                             thanks
                                                                                                          Curt