Messages

HI go carefull using champion the new ones are a load of trouble with a magneto new name for them is crapion!! ,once gave my fordson (n) a pre season service including new correct plugs ,wound that engine over all one afternoon would only cough and fart, re installed old plugs fired right up on first half pull up on handle sending a load of crap up the exhaust pipe hence i will not look at a nother champion
(try autolite)     
All the best for Christmas from north north yorkshire   

HI please can some one help I am in need of 2or3 track pads for model F 1921 the old ones are cracked
this call for help comes from north yorkshire thanking you Doug

HI had same problem on hg31 my line of attack is remove drive shaft guard to gear box get a PARE OF 24"STILSONS (MONKEY WRENCH)
attatch to drive shaft with aprox of 6"gap from stilsons end of shaft to somthing solid give engine a hefty kick on starting handle
stilson handle will come suden stop shock should free off plate with no strain on gear box or transmition hope this is useful

HI check rotation by mag by impulse or arrow on rotor arm

HI make shure starter motor is not at fault bendix could have stuck

cold starting trick when stopping engine close shut off revs stall engine by choke just make shure you have a good spark on mag

hi just found E31 been re engined with a ferguson T20 engine laid up in shed a long time  would it be worth
going after it is for sale :?:

HI Blake and bob thankyou for your replies thanks fron north north yorkshire

please help how can i free off track lower rolers on a cletrac en track adjusters appear to hydraulic thanks for any answers :?