Here's a photo. 32 pads I think; does that sound right?
- Welcome to Cletrac.org.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
HG, OC-3, OC-4 & General / OC-4 tracks?
November 08, 2011, 01:12:17 AM
Hi guys-
My brother dropped off an OC-4 for me to play with. We're trying to figure out these tracks; the grouser or pad is offset from the chain, meaning not centered on it. I've never seen a set like this, but then again I haven't looked that closely. There is only 1/2 to 5/8" clearance between the track and some frame parts.
Is this an original track or did someone cut them down? They are pretty well worn, and I'm watching for a better set. I found an 8" wide set from an OC-3 that I think will work. In the past I've seen 10" and 12" from an air track drill but they are too wide unless the track frame and sprockets are spaced out.
-Gerry
My brother dropped off an OC-4 for me to play with. We're trying to figure out these tracks; the grouser or pad is offset from the chain, meaning not centered on it. I've never seen a set like this, but then again I haven't looked that closely. There is only 1/2 to 5/8" clearance between the track and some frame parts.
Is this an original track or did someone cut them down? They are pretty well worn, and I'm watching for a better set. I found an 8" wide set from an OC-3 that I think will work. In the past I've seen 10" and 12" from an air track drill but they are too wide unless the track frame and sprockets are spaced out.
-Gerry
Pages1