torque specs for 3cyl herc.

[james]

Hello all, I know I havent posted in some time, but I finally got back to working on my oc46. I sent the engine ( which is a sleeveless G130H herc engine) to have it bored and sleeved. It had a bad crack in the center cyinder. I ordered new bearings and rings and I am now set to reassemble it. What I need to now are the torque specs for the rod and main bearings  and the head gaskets torque specs. Thanks guys I will post pics soon.

[Robert Barbour]

Head 140, rods, 70  Center main 70, front and rear main 80, cam gear nut 130,flywheel 80.

[james]

ok next there are 4 little copper washers .. I am not sure of where they are supposed to go. I have the old ones which have yellow paint on them. So I assume they are on the OUTSIDE of the engine, Im just not sure where they go. I should have paid more attention when I took it apart .

[james]

Ok guys. I dont know whats I did or whats going on but this thing is filling the rear 2 cyls with antifreeze. I am done putting money into this thing. I have just put $940 alone into the engine. anyone that would like to make me an offer on this tractor is welcome too. I realise that I will not get out of it what i have into it. I would just like to recoup some of my money so I can buy something else. If interested please call me at 716-467-2403. My name is James

[hotratz]

James, You might try posting this information in the "Classified" section for better results.