HG 42 Throttle lever

[yellowcrawler]

I bought a new throttle lever to replace the cobbled replacement.  Since I have not seen an original installed, does a 1/4 inch ball or a pin fit along with the spring in the body of the lever?

Thanks,
Walter.

[walter hudson]

the lever should have a piece of hardened rod that is ground like the edge of a chisel but not a real sharp point .
                                                      walter

[yellowcrawler]

Thanks for the information on the pin, I will make up one.  

Is a pin used for the pivot point on the lever?  A long 1/4 inch bolt is used as a pivot on the present lever.  

I have the proper clevis for the rod to the governor.

Thanks,
Walter

[walter hudson]

I normally use a bolt with a lock nut.

[yellowcrawler]

Thanks for the information!!

Walter.